Fetch TV Setup Guide

Fetch TV Smart DNS Setup Guide

Follow this simple guide to set up UnGeo Smart DNS on your Fetch TV box using the built-in network settings.

Fetch TV Smart DNS setup background
Fetch TV

Before You Start

Before changing your DNS settings, make sure your UnGeo account is active and your current IP address is added in your Client Area. If that is already done, continue with the DNS setup below.

1

Don’t have an account yet?

Choose a plan and create your UnGeo account before setting up DNS.

Get Started ›
2

Add your current IP address

Add your current IP address in the Client Area to allow UnGeo to work properly.

Register My IP Address ›

Once both are done, continue with the DNS setup steps.

Step-by-Step Setup Guide

1

Open Fetch TV Menu

Press the Menu button on your Fetch TV remote.

2

Go to Manage

Open Manage from the main menu.

3

Open Settings

Select Settings to view your Fetch TV system options.

4

Go to Network

Select Network to open your current network settings.

5

Open IP Settings

Find IP Settings or the current internet connection settings for your Fetch TV box.

6

Change IP Settings to Manual

Change IP Settings from Automatic to Manual. This allows you to edit DNS settings.

7

Keep Current Network Details

Keep the current IP Address, Subnet Mask, and Gateway values unchanged unless your network requires different manual settings.

8

Enter Your UnGeo Smart DNS servers

In the DNS Server 1 field, enter the primary UnGeo Smart DNS server shown in your Client Area. If DNS Server 2 is available, enter the secondary UnGeo Smart DNS server as well.

9

Save Your Changes

Select Save, Apply, or OK to store the new network settings.

10

Restart Fetch TV

Turn your Fetch TV box off and back on so the new DNS settings are applied.

11

You’re All Set!

Your Fetch TV box is now ready to stream your favorite channels with UnGeo Smart DNS.

How to Check If It’s Working

Visit the UnGeo DNS Check page to verify whether your device is using UnGeo Smart DNS correctly.

Go to DNS Check →

Troubleshooting

Open Menu → Manage → Settings → Network. On some Fetch TV models, the menu names may vary slightly depending on the software version.
Change IP Settings from Automatic to Manual first. Fetch TV usually shows editable DNS fields only after manual network settings are enabled.
This is normal when Manual setup is enabled. Keep your current network values unchanged and only replace the DNS fields with your UnGeo Smart DNS servers.
One of the manual network values may be incorrect. Switch IP Settings back to Automatic, reconnect to the internet, then repeat the setup carefully.
Make sure your UnGeo account is active, your current IP address is added in the Client Area, and the UnGeo Smart DNS servers were entered correctly. Then restart Fetch TV and reopen the streaming app.
Visit Support Center →

FAQ

Yes. Fetch TV can use UnGeo Smart DNS if your Fetch TV box allows manual DNS configuration in the network settings.
Open Menu → Manage → Settings → Network, then open IP Settings and change the setup from Automatic to Manual.
No. UnGeo Smart DNS works through your Fetch TV network settings and does not require an app.
No. In most cases, keep the current IP Address, Subnet Mask, and Gateway values unchanged and only change the DNS fields.
Yes, if your Fetch TV box shows DNS Server 1 and DNS Server 2. Enter the UnGeo Smart DNS servers shown in your Client Area.