WD TV Smart DNS Setup Guide
Follow this simple guide to set up UnGeo Smart DNS on your WD TV or WD TV Live using the built-in network settings.
Before You Start
Before changing your DNS settings, make sure your UnGeo account is active and your current IP address is added in your Client Area. If that is already done, continue with the DNS setup below.
Don’t have an account yet?
Choose a plan and create your UnGeo account before setting up DNS.
Get Started ›Add your current IP address
Add your current IP address in the Client Area to allow UnGeo to work properly.
Register My IP Address ›Once both are done, continue with the DNS setup steps.
Step-by-Step Setup Guide
Open WD TV Settings
From the WD TV home screen, open Settings.
Go to Network Settings
Select Network Settings from the settings menu.
Open Network Setup
Select Network Setup to view your current connection settings.
Select Automatic First
Choose Automatic and wait until WD TV receives the IP address and network settings from your router.
Open Network Setup Again
Go back to Settings, open Network Settings, and select Network Setup again.
Select Manual Setup
Choose Manual so you can review and edit the network settings.
Keep Current Network Details
Keep the current IP Address, Subnet Mask, and Gateway values unchanged unless your network requires different manual settings.
Open DNS Field
Scroll down to the DNS field and press Enter on your remote.
Enter Your UnGeo Smart DNS server
Enter the primary UnGeo Smart DNS server shown in your Client Area.
Save Your Changes
Select Submit, then choose Finish and OK to save the new DNS settings.
Restart WD TV
Turn off your WD TV using the power button on the remote, wait a few seconds, then turn it back on.
You’re All Set!
Your WD TV is now ready to stream your favorite channels with UnGeo Smart DNS.
How to Check If It’s Working
Visit the UnGeo DNS Check page to verify whether your device is using UnGeo Smart DNS correctly.